Joined
·
2,605 Posts
You have had to much beer Mike. :laugh2:
I am not sure if this will work but here goes. I have done this while routing a sign. To start I lay down a sheet of Duck brand clear stick on shelf. I make sure it's straight and then I run a roller over it to make sure it sticks good and there is no air pockets. I then carve the sign and when through I make sure the shelf paper is still stuck down around where the router bit has been. I then spray paint and let it dry then peel off the shelf paper.
Hope this helps.
I am not sure if this will work but here goes. I have done this while routing a sign. To start I lay down a sheet of Duck brand clear stick on shelf. I make sure it's straight and then I run a roller over it to make sure it sticks good and there is no air pockets. I then carve the sign and when through I make sure the shelf paper is still stuck down around where the router bit has been. I then spray paint and let it dry then peel off the shelf paper.
Hope this helps.
