Router Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
A friend sent me an stl of this and asked me to make one for her husband on their anniversary. It was the song sung at their wedding. She found it on the web. The font was a little tricky to work with but I think i turned out ok. I have practically retired from my cabinet shop and now get to "play" with some of my equipment. This was cut on my 4x8 4hp cnc that has cut many kitchens. A lot of machine for this job, it is what I have. I intend to do a lot more of this kind of projects. I have done some 3d work in the past for presents and such as well on this machine. Just thought I would finally share a project.
398010
Handwriting Wood Headgear Font Fashion accessory
Handwriting Wood Headgear Font Fashion accessory
 

·
Super Moderator
John
Joined
·
6,973 Posts
Nice job, letters turn out nice inside the heart well placed
 

·
Registered
Joined
·
40 Posts
Discussion Starter · #7 ·
Great job on that! I have some Corian to play with but have yet to cut it. What bit did you use, feeds and speeds, too, if you don't mind?

David
Thanks David. I used a Whiteside 1/4" 60 Degree vcrave bit. I ran at 70 in/min. Th font that was used mimics hand script. It has a lot of waves and crossover vectors so I thought it best to run slowly to get a good sharp edge to pour the epoxy to.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top