Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello -

I work in a college shop, and we just recently purchased a set of templates used for top flush trimming. I was wondering how they worked. Specifically, how much space there should be between the bit and the template. It seems the bits we have are either quite snug in the template or have way too much space. Any suggestions? Thanks!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top