Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am building a small boat from a set of plans.
I need to flush trim the side plywood to the bottom plywood, This is not at right angles
I want to set the router on the side of the boat and flush trim the wood to the bottom. the angel is 67 degrees.
So it would ge great if the base tilted but the Dewalt 625 does not have that feature. So any ideas on how I could do this. could some sort of a angled shim be attached to the base of the router,
Jeff
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top