Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
114 Posts
Discussion Starter · #1 ·
I AM ASKING $60 (PLUS SHIPPING) OR BEST OFFER. PAYMENT BY PAYPAL OK.
Crankset Hand tool Bicycle part Tool Groupset
Motor vehicle Automotive tire Crankset Gas Auto part
Font Material property Circle Metal Hard disk drive


THE MACHINE IS A COMMERCIAL GRADE 1HP ROUTER WITH AN OPERATING SPEED OF 25000 RPM..IT OPERATES WITH 110-120 AC-DC, 25-60HZ,
6 AMPS. IT IS 100% BALL BEARING CONSTRUCTION, AND IS MARKED AS SUCH ON THE DATA PLATE.

THE KIT INCLUDES THE CRAFTSMAN EDGE GUIDE AND CONTOUR FINGER FOR SHAPING EDGES WHEN CUTTERS HAVING NO PILOTS ARE EMPLOYED, AND FOR MAKING ALL TYPES OF CUTS REQUIRED TO BE PARALLEL TO THE EDGE OF THE WORK. WHEN THE CONTOUR FINGER IS ATTACHED TO THE EDGE GUIDE, AND POSITIONED UNDER THE CUTTER FOR THE DESIRED WIDTH AND DEPTH OF CUT IT WILL ENABLE THE OPERATOR TO ROUTE A UNIFORM CUT ON IRREGULARLY SHAPED EDGES.

THE KIT ALSO INCLUDES THE CRAFTSMAN No. 25164 TRAMMEL POINT ATTACHMENT.
THE ROUTER HAS BEEN USED BY ME, BUT NOT ABUSED. I BOUGHT IT NEW.
Please send me a PM for more information.
RICK
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top