Router Forums banner
1 - 1 of 9 Posts

· Registered
Joined
·
8,958 Posts
That round Chevron cutting board is well done. My one comment that I see right away is a lot of waste. The boards are ripped, glued together straight ,then cut on an angle, creating a lot of waste going from straight and square to the angle. then glued together and cut round, again more waste. Not in a negative sense, just that you have to figure a lot of extra material to make a board that design. It came out quite nice in the end.
Herb
 
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top