Router Forums banner

Forgot a groove - now what?

3K views 9 replies 5 participants last post by  BobandRick 
Scotty said:
Hi Bob and Rick,
I'm still trying to get this drawing to you. Here goes..

Thanks,
Scoty
Looks like your going to have do a little hand work.

I would put a 3/16" spacer piece between the legs then set the V-groove up to cut the groove in the rail. Make sure you don't touch your legs on the start or finish position. Last is to cut by hand the bit you will miss on the start and finish points of the V-groove.

Good luck and think and set up safely
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top