Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Don't have direct answer for FT2200, but I recently picked up a Rockler portable table and tried with a few routers that I have. What I found is Rockler had quite limited models that are supported (at least officially supported based on the tech support). You can found the official supported list from their website under the product section. That's said, I was able to matched the pre-drill holes for both Milwaukee (5615) and Makita trim router, even though neither was on their official supported list. However, I have less luck with the vintage Craftsman. I ended and drill the holes myself for the Craftsman.
 

·
Registered
Joined
·
12 Posts
Agree. I just found that the hard way. Called the Tech Support for FT2020 locknut. Was told that it was discontinued and no information could be provided.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top