Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a Freud FT3000VCE router that has 4 base plate mounting holes.

Every template I can find, including the one included with the manual has 3 mounting holes that are completely different.

Does anyone have a Frued FT3000VCE 4-hole template?
 

·
Registered
Joined
·
2,825 Posts
Hello N/A You may want to check the router reference on the jump menu and select the freud section there. Also the router raiser shows the 4 bolt mount. You can make your own if you so desire,(This is not hard to do) Or you should be able to order it from the table manufacturer If you do make one, Make sure that the hole marks are perfect, and the center hole especially must be perfect. It is uses with the bushings or collar
which rub the template. So any difference is magnified when the router is turned
 

·
Registered
Joined
·
10,671 Posts
Greetings (your name here) and welcome to the router forum. Please take a moment and fill in your profild, Thanks a bunch.
 

·
Registered
Joined
·
312 Posts
I have a Freud FT3000VCE router that has 4 base plate mounting holes.

Every template I can find, including the one included with the manual has 3 mounting holes that are completely different.

Does anyone have a Frued FT3000VCE 4-hole template?
You need to remove the base plate from the router to access the three mounting holes that the templates refer to.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top