Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
hi folks ! new to this forum for posting but have been checking it out from time to time. I am relatively inexperienced with a router table but not routers. Iv'e read some really neat tips and tricks on this sight and thought I should probably just go ahead register. I'll say also trying to absorb it all at once has always been a bad habit of mine... lol. I can see with the versatility and endless possibilities of a router table that's not happening. so I guess a little patience and persistance will be in order. Having said all that ...I had a question. ...Dose anyone have any ideas on how I can transfer the position (accurately) of where I need to drill my Alum. proplate for a new freud 3000 3 1/4 hp ? The problem is not only the mounting screws, but also the holes for the above table spindle lock as well as the above table micro adj. knob holes. I'm thinking maybe a drill press is required!...? anyone ever hand drill a new blank plate before? Any help will be greatly appreciated. Thank you .Oh I forgot...! one problem I'm having is finding dead center of mounting screw holes with a paper template I keep trying to make.. any advice ?...
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top