Router Forums banner

Fun Project....Spinning Wheel

2254 Views 3 Replies 4 Participants Last post by  Dr.Zook
I have this old MasterCraft(Delta Div.of Rockwell in the old days)bench lathe which I built a stand for a number of years ago.
My wife wanted a spinning wheel so this one is made from red oak which is what I had in my little shop.Without outboard turning capability I had to "finish turning" the 24" dia. wheel using a router mounted on my RAS & rotating the wheel under it on a turn table. Thanks for looking.



See less See more
1 - 4 of 4 Posts
WOW!! Very nicely done!!
Oh wow, yet another really nice work Lee.. very nice job!
Congrats Lee. You should have a very contented wife. That is a very impressive spinning wheel. Keep up the good work.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.