Joined
·
208 Posts
I have this old MasterCraft(Delta Div.of Rockwell in the old days)bench lathe which I built a stand for a number of years ago.
My wife wanted a spinning wheel so this one is made from red oak which is what I had in my little shop.Without outboard turning capability I had to "finish turning" the 24" dia. wheel using a router mounted on my RAS & rotating the wheel under it on a turn table. Thanks for looking.
Lee
My wife wanted a spinning wheel so this one is made from red oak which is what I had in my little shop.Without outboard turning capability I had to "finish turning" the 24" dia. wheel using a router mounted on my RAS & rotating the wheel under it on a turn table. Thanks for looking.
Lee
Attachments
-
15.7 KB Views: 175