Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hi guys,
I'm doing a lot of reading and soon I'm going to give my new to me cnc router it's first run.

I thought I seen in vcarve pro
Or Mach3
A tab that showed commonly used files , like
Cut a slot, cut a pocket ,surface stock etc.
Could someone point me to that tab please.
I just want to run a very simple file to carve for my first time

Thanks in advance

Danny
 

·
Registered
Mike
Joined
·
3,959 Posts
Danny look at the Wizards for the basic shapes.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top