Router Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I picked up a 10 inch Ohio Forge (RIP) benchtop table saw. I finally got the motor to align, but the screws controlling tilt and elevation are kicking my behind all over the place. I can't seem to find anyone with a manual, and there are no pictures of any to be found. I would REALLY appreciate it if someone with a lot more experience than me could tell me what screws go where. None of the shops around here will touch it, due to it's antiquity. Please, for the sake of my marriage, HELP!:help:
 

·
Registered
Joined
·
12 Posts
Discussion Starter #4
Yeah, it kind of sucks. It's my first tablesaw because of the crushing poverty, so I really have no Idea what's going on in there.
 

·
Premium Member
Joined
·
3,503 Posts
Thomas,

If you go to Inexpensive portable table saw? - Woodworking Forum - GardenWeb you will find they are talking about 10" Ohio Forge saws. Someone references that Craftsman had an identical saw, apparently from the same manufacturer. This may be a thread you can follow to get your answer.

To find it (and other leads) I googled

"ohio forge" table saw manual

You might also try that!

Jim
 
1 - 5 of 5 Posts
Top