Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
377 Posts
Candle is designed to talk to a GRBL based machine. So I would choose a GRBL post processor in your design software, it should create compatible g-code.

I have seen recommendations for a 1/8 bit in wood at .5mm depth of cut, 3mm/second. Apparently many of the machines have issues with GRBL that limits control of the spindle rpm.

Information for the Sainsmart 3018 Pro version can be found here:
101-60-280PRO - [[:Template:SainSmart Wiki]]

David - The 3018 are sub $300 CNCs with a postcard sized cut area and a 300-400W spindle.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top