Router Forums banner

General question about sub-bases

1809 Views 2 Replies 3 Participants Last post by  Mike
Does anyone know of any place that has the hole patterns for routers listed, various brands/models?

1 - 1 of 3 Posts
Ed: I don't think they list them that way. But if you go to the Oak Park web site,
they have a listing of which plates fit which routers with a little extrapolition you may
be able to figure it out. They have a plate that fits four hole and three hole routers
and then identifiys the particular brands, ie PC, Makita etc The big PC routers
use special plates because of the large screws, like the 7518, and 7539. Hope this
helps a little.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.