[markengineer]

So, my x -axis stepper motor is running too fast! It is not stepping. All the other steppers jog and move correctly but the x is way too fast I have ran different types of files, reinstalled Grbl Control software, unplugged, reset and checked every connection. At this point I think I have a bad stepper or the controller is bad.

Any Suggestions?

Thank Mark

 

[jw2170]

Welcome to the forum, Mark

Someone with more knowledge on the subject should be along to help you.

Apart from Grbl Control software, what other software are you using?

 

[markengineer]

So, my x -axis stepper motor is running too fast! It is not stepping. All the other steppers jog and move correctly but the x is way too fast I have ran different types of files, reinstalled Grbl Control software, unplugged, reset and checked every connection. At this point I think I have a bad stepper or the controller is bad.

Any Suggestions?

Thank Mark

ANSWERED!
So, a nice gentleman from SainSmart had me enter these test codes into the Candle Console and it reset the stepper motor or controller to defaults.
Working fine now!

$21=1
$22=1
$30=10000
$27=3
$100=160
$101=160
$102=160
$110=2000
$111=2000
$112=2000
$120=300
$121=300
$122=300
$130=420
$131=310
$132=110

 

[jw2170]

Glad you got it sorted, Mark.

 

[old55]

Welcome to the forum Mark.