Router Forums banner
Cancel

Genmitsu ProVerxl4030

1215 Views 4 Replies 3 Participants Last post by  old55, 
M
So, my x -axis stepper motor is running too fast! It is not stepping. All the other steppers jog and move correctly but the x is way too fast I have ran different types of files, reinstalled Grbl Control software, unplugged, reset and checked every connection. At this point I think I have a bad stepper or the controller is bad.

Any Suggestions?

Thank Mark
Reply
Save
Like
1 - 2 of 5 Posts
M
markengineer said:
So, my x -axis stepper motor is running too fast! It is not stepping. All the other steppers jog and move correctly but the x is way too fast I have ran different types of files, reinstalled Grbl Control software, unplugged, reset and checked every connection. At this point I think I have a bad stepper or the controller is bad.

Any Suggestions?

Thank Mark
Click to expand...
ANSWERED!
So, a nice gentleman from SainSmart had me enter these test codes into the Candle Console and it reset the stepper motor or controller to defaults.
Working fine now!

$21=1
$22=1
$30=10000
$27=3
$100=160
$101=160
$102=160
$110=2000
$111=2000
$112=2000
$120=300
$121=300
$122=300
$130=420
$131=310
$132=110

Attachments

See less See more
Reply
Save
Like
  • Like
Reactions: 2
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Router Forums
A forum community dedicated to router and woodworking professionals and enthusiasts. Come join the discussion about different types of routing and routers, shop safety, finishing, woodworking related topics, styles, tools, scales, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
New Member Introductions Tools and Woodworking General Routing Table-mounted Routing Show N' Tell
Top