Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
558 Posts
If you have the bits for cutting the stiles and rails all you need is a rabbeting bit to cut the back for the glass panels. The few times that I have done this I used the stile cutting bit to mold both edges of some spare door stock.cut these free on the table saw and this molding was used to hold the glass in. Gives a nice finished door on both sides.

Regards
Jerry
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top