Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
110 Posts
Discussion Starter · #1 · (Edited)
Jig made to join narrow boards edge to edge. Uses threaded rod(any length) and 2 rabbeted boards rabbets facing up to capture the board edges. No need for clamps. Holes are bored simultaneously for alignment just under the rabbet to fully support the boards.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top