Router Forums banner
1 - 1 of 1 Posts

·
Retired Moderator
Joined
·
4,126 Posts
Discussion Starter · #1 · (Edited)
Got it done and seemed to work just fine. I have done a how too tutorial that I posted in the How To section. Here is the link:

http://www.routerforums.com/project...ig-non-oak-park-table.html?posted=1#post32812

It went pretty well however I do know that I hate routing MDF. It dulls bits very quickly and chips out bad. In fact the Aspen did some chipping out as well. Please tell me with the spiral bit that I won't get much chip out in nice hardwoods :eek: Anyway what yah think?

Corey
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top