Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Good evening all. Thanks for having me on the forum. Much appreciated.
I've just started the whole woodwork thing and plan to build my own 3-in-1 DIY table saw with router and jigsaw. Rather than go new, I bought a used router with accompanying bits on Ebay to just get used to things before I go bigger and better. It's a Black & Decker kw800 710w. Bits are 1/4" Piranha. When ai put them into the collet and tie the nut they still just flop out without even touching the sides. I've used the spanner and all. Could it have a 8mm collet on perhaps? I'm at a loss.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top