Joined
·
2 Posts
Hello Router Forum Team,
I am looking to build Jack Cox's Pivot Frame Jig and use my small Dewalt trim router's plunge base. I have been looking for specifications for the base, such as the size of the rod holes that go through the base, I measured 8.5 mm. What is the screw size that clamps the rods in the slots? I believe they are metric as well. I have been looking for the specifications but they are not published anywhere have found. Also, the spacing of those holes. FYI, the base model number is DNP612...if that helps...
I would be nice if Dewalt published this information but their site is only a sales site.
Thanks
Denis
I am looking to build Jack Cox's Pivot Frame Jig and use my small Dewalt trim router's plunge base. I have been looking for specifications for the base, such as the size of the rod holes that go through the base, I measured 8.5 mm. What is the screw size that clamps the rods in the slots? I believe they are metric as well. I have been looking for the specifications but they are not published anywhere have found. Also, the spacing of those holes. FYI, the base model number is DNP612...if that helps...
I would be nice if Dewalt published this information but their site is only a sales site.
Thanks
Denis
