Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
558 Posts
First of all a flush trim bit has the bearing on the bottom,a pattern bit has the bearing on the top(above the cutting edge). If you are using either type bit to trim to a pattern or what ever,use the largest diameter bit you have. Check Pat Warner's site or read some of the router books available. Do not expect to get all you information from this or any other forum. The late Dr. Roger Cliffe used to say "want to be a better woodworker - do more woodwork.

Good Luck
Jerry
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top