Hi, English: Guide bushings that I have, are 1/4" below the bushing. If your bushing is longer than 3/8" you will have to make the temple thicker, like 3/4 ". Apparently
the person writing the article had bushings that had shorter sleeve length. Using
a thicker bushing will allow you to cut the material below the template if you are using the router hand held. If using the router in a table the template is on the bottom and the material will be above it. The important thing is the length of the bit, since ti must go down 3/4" plus the thickness of your material..
Hope this helps.. Woodnut65
the person writing the article had bushings that had shorter sleeve length. Using
a thicker bushing will allow you to cut the material below the template if you are using the router hand held. If using the router in a table the template is on the bottom and the material will be above it. The important thing is the length of the bit, since ti must go down 3/4" plus the thickness of your material..
Hope this helps.. Woodnut65
