[Hamlin]

I for one have always been confused by the metric system, (always will be), but, I'm like Mike, I don't work with it very much.

Tom, could you by chance post a pic of the 40mm? I have a Makita3612C, purchased through amazon, and I don't have any guides except that from Oak Park.
Also, I think you answered this one other time not sure, do you use any type of bit extension(s) with your guides?

 

[Hamlin]

Many thanks Tom.

I love the router, excellent for hand held and table work both. I've checked their web site, shows only 2 for the model. I think I'll be making a trip to a local retail and see if I can order some bushing/guides for it. Being in the US, not sure if they'll have the 40mm but.... I can be stubborn and tell 'em get me one!!
Again, thank you.

 

[Hamlin]

Just a slight update...
Checked their web site (Makita), there are several bushings to choose from. The 40mm isn't listed. However, the site does list other outlets that sell Makita products, so, hopefully may be able to stop in at one of those places and possibly special order it. I hope.