Router Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I made some nice fitting half blind dovetails with 3/4 inch boards with the Porter Cable 4210 jig. What do I change when using 1/2 inch boards. I would expect the bit depth would be half of the board thickness. What about the template alignment? Do I line the boards up with the same groove in the template? It seems that the pins would be to deep then.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.