Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Howdy,

Has anyone used an Incra Original jig with a Bench Dog Pro Contractor table? I am wondering if the jig will fit the table. The BDC table looks a bit small, and I don't see a size requirement in the Incra documentation.

Best,
Mike
 

·
Registered
Joined
·
2 Posts
I have used the Incra 17 inch LS system with the Bench Dog Contractor. On both sides of the unit I bolted aluminum box track and built an extension of the Bench Dog contractor to it. I was able to mount my LS 19 1/2 inches beyond the table top. You can also add 2 shelf brackets to the rear of the unit to support the addition if necessary.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top