Router Forums banner
1 - 1 of 2 Posts

· Registered
2,046 Posts
What I learned from a WWGOA video was how to accurately measure the error of a miter gauge which I did with my Incra SE1000. By making a 6 sided frame and assembling it the final fit would show 6 times the error of say just t cuts fitted together. I found mine barely needed adjustment and my second set was tight all around. How many thousands I can't say but less then 3 as a piece of paper would not fit between the final 2 pieces. I have yet to check my 3 table saw sleds which I really should.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.