Router Forums banner
1 - 1 of 2 Posts

· Registered
1,878 Posts
Discussion Starter · #1 ·
Under the heading of thinking too much I was wondering if it was possible to use William NG's 5 cut method for a perfect 90° crosscut table saw sled and use the methodology for a 45° sled. If it is has anyone made one?

My Dubby is .002 at 90° and figured if I took the time for that I may as well double check its 45° mark. MY eyeball says its good which has a voice.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.