Router Forums banner
1 - 20 of 32 Posts

·
Registered
Joined
·
3,456 Posts
Looks to me like a puzzle - and could incorporate small drawers

Piece #1 into slot #1

Piece #2 into slot #2

Piece #5 into slot #5

Piece #3 into slot #3

Piece #4 against slot #4

Base

Front and Back

Not sure what the small square is for - another base??
 

Attachments

·
Registered
Joined
·
11,747 Posts

·
Registered
Joined
·
3 Posts
2 goes on the front of 1
3 goes on the back of 1
The two points of 5 sit into the base of 1
4 looks to be a head.
6 looks to be a shoulder, but then you would need two.......
Which would make 9 an arm, but you would also need two......
A would be a cover for a book, but again, two needed.
8...... ?
7 is a base.

The tile looks to be 12 inches wide for a size frame.

As to the cutting of them, the flat base of 5 slides into 1. 4 slides into the top of 5. 8, prongs up slide into the bottom of 5. 9 into the gap of 8. 6 is from a separate layer assembly. But all of that is just an artful way of making parts.

You got me hooked on this........
 

Attachments

·
Registered
Joined
·
1,998 Posts
Discussion Starter · #14 ·
Sorry lads, been very busy making a gazebo for she who must be obeyed. 3 x 9 hour days so far and a couple more to go. i never did this much work when I was gainfully employed!

OK, some pointers;
Those tiles are not 12" they are 18"

4 & 6 will not be in the final build.
7 is not a base.
 

·
Registered
Joined
·
1,998 Posts
Discussion Starter · #15 ·
sorry folks, life got in the way for a couple of weeks, but I'm back.

Number 4 was a waste off cut from the main body, so with the addition of two ends from the scrap box it got turned into a little treasure chest;








6 and 9 are scrap.
And "A" was stuck on the end of 8 and shaped to fit.
 

·
Registered
Joined
·
1,651 Posts
Yes, Bob, all well and good, but what's the rest make?

That treasure chest is beautiful. Shows there's no such thing as scrap.
 

·
Registered
Joined
·
1,998 Posts
Discussion Starter · #17 ·
Angie, the best things come to those who wait....

I really like this little box, considering it was a spur of the moment "what can I do with this" kind of thing.
its about 4" max in each direction. the hinge is a 5 mm brass rod through the whole lid and concealed in the end pieces.
 
1 - 20 of 32 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top