Router Forums banner

1 - 16 of 16 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Hey gang,

Just setup a bench dog pro cast iron top/cabinet/pro fence with a Milwaukee 5625. Just finished wiring and mounting a metal gang box with two outlets and power switch. I'm ready to tinker now.

-Roy
 

·
Registered
Joined
·
31,264 Posts
Hello Roy from central Colorado..
an welcome...
tinkers we gots so yur not more than a keystroke way from the party....
need to know ... ask...
don't need to know...
ask anyways...
 

·
Registered
Joined
·
3,007 Posts
Hey, Roy. Always happy to welcome a fellow Texan to the Forums. Don't be a stranger.
 

·
Retired Moderator
Joined
·
16,385 Posts
Hi Roy and welcome to this forum. You got a question to ask then post it. You got something you think we'd like to see then post that too.
 

·
Official Greeter
Joined
·
18,742 Posts
G'day Roy. Welcome to the forum.
 

·
Registered
Joined
·
4,625 Posts
Welcome Roy...you're gonna like it here...lots of tinkerers.
 

·
Registered
Joined
·
2,983 Posts
Welcome to the forum, Roy.
 

·
Premium Member
Joined
·
19,223 Posts
Welcome to the Forum Roy. Nice bunch of folks here and lots of help as you get going. You have a pretty nice setup to start with.
 

·
Registered
Joined
·
22 Posts
Discussion Starter #13
Yes, I do believe this will be a good place to be from time to time. I have just two more areas to address with my setup and that is ordering the Bench Dog Jointer bars (they call them bars, but I prefer shims) since my fence did not come with them. Finally, I need to search on the most efficient way to cut a 3 11/16ths (true as possible) inch hole in 3/4" plywood. I need to make a dust collection support block.

-Roy
 

·
Official Greeter
Ross
Joined
·
8,317 Posts
Welcome to the forum Roy.
 

·
Registered
Joined
·
675 Posts
Welcome from the Golden Gulf Coast Roy!
From down south near Freeport.
 
1 - 16 of 16 Posts
Top