Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
New to the forum. Just now making the jump to a Rockler Router Table with a lift, and looking for some info. on good ways to make blind dados for some cabinet door rails and stiles.
 

·
Banned
Joined
·
11,934 Posts
Once you have your bit installed place a piece of wood on one side and use this to transfer a mark to your fence. Repeat for the other side of the bit. Now you have a visual reference so you can swing your wood onto the bit to start your cut and stop short of cutting through at the end. You can also clamp stop blocks to the fence to limit the travel of the wood.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top