[jpbldr]

Hello. Just registered after lurking for awhile as I was researching CNC tables. Probotix Comet ordered. Can't wait to start cutting!

Brian

 

[Semipro]

Hello and welcome Brian

 

[chessnut2]

Welcome, Brian!

 

[Roy Drake]

Welcome, Brian. Ask questions and enjoy.

 

[difalkner]

Welcome to the forum, Brian! Be sure and post photos of that new Comet when it arrives. We like 'em start to finish! Ask away if you have questions - someone here will have an answer, often the correct one. :wink:

David

 

[RainMan 2.0]

Wow there’s some early birds here lol . Welcome to the forum Brian . Can’t wait to see your new toy

 

[Cherryville Chuck]

Hi Brian and welcome.

 

[Shop guy]

Welcome to the forum, Brian.

 

[jpbldr]

Thanks for the warm welcome!

Wow there’s some early birds here lol .....

More like night owl:laugh2:

On dust control, my plan is to use a cyclone (Oneida) along with a HEPA shop vac. Seems some have done this with good results. I want it to be integrated into the table for the machine, and need it to filter well. Opinions on similar setups you have used?, HEPA vacs vs standard shop vacs? Quieter the better!

Brian

 

[old55]

Welcome to the forum Brian.

 

[marecat3]

Welcome Brian

 

[jpbldr]

Comet arrived earlier this week. Should have the base ready to set the machine on tomorrow, then work on mounting all the gear. Hope to have it up and running by the end of the weekend.:smile::smile:

 

[jpbldr]

Here it is! Made the first cuts tonight on some scraps of foam board. :smile: