Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
404 Posts
You may need to enable the "charge Pump"

Greetings, I’m new to the forum. I need help with my 48x48 Zenbot. I purchased it over a year ago and i haven’t been able to get it started. I switched the parallel port, however it’s still inoperable. Please help if anyone can.
Welcome
I think your router most probably use the Gecko 540 controller (please confirm yes or no).

If so you may need to enable the "charge Pump" interface.

Here is the correct instructions if you are using MACH 3.
Ref:
https://www.geckodrive.com/support/step-drives/g540-initial-setup-guide.html

If you are not using the Gecko 540 please let me know the Controller board model number (open the box) and I may be able to help you with a different instruction to get you going.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top