Router Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello everyone, I am a machine operator of a Rover A FT, if anyone knows how to add machining operation on bsuite Cad/Cam software.

I am trying to add the 3d Engraving Machining operation on the Machining options on bsuite software but I cannot seem to figure it out.

Thank you in advance..
 

· Official Greeter
Joined
·
20,385 Posts
Welcome to the forum, @dhobbyist .

You may get a better response if you post your question in the CNC section of the forum.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top