Router Forums banner
1 - 1 of 4 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I'm happy to be part of your forum. I'm new to using a router have much to learn. My intent is to use it to create moldings to be used in rehab houses. The process is just now getting off the ground and, sadly, I am hitting some snags, most particularly in creating a chatter-free profile. Hopefully this matter has been addressed before but if not I welcome any advice you folks can offer.

1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.