Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
I'd suggest that you'd be best to use a spiral downcut bit for shallow mortising. The finish will be better than you can achieve with an upcut bit, particularly on any cross grain areas, and loads better than a more conventional two flute straight mortising bit. Have a look at the attached pic's. for a comparison. Spotted gum is a hard Australian eucalypt.
398480
Wood Rectangle Font Material property Wood stain
398481
Table Rectangle Wood Flooring Floor
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top