Router Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I am looking to buy a router table, preferbly a full-size. I am looking on amazon.com and I am looking to spend around $350. My main objective is crown moldings and simply router edges.

Suggestion???
 

·
Registered
Joined
·
23,786 Posts

·
Registered
Joined
·
23,786 Posts
Hi Dohcser

Bosch makes great tools, I like the RA1181 over the RA1171 but that's just my 2 cents :) and it should work great for you.

But 200.oo bucks + 60.oo bucks + plus a router and your over your max by about 100.oo bucks, if all you want to do most of the time is ("crown moldings and simply router edges") you may want to look at a floor model shaper like the one from Grizzly ( 3/4 HP ) that comes ready to go so to speak, it's hvy. duty (cast iron & steel ) the cutters are almost the same as most router bits.

at @ 170.oo bucks
http://www.boschtools.com/tools/tools-subcategory.htm?H=175980&G=54940

at @ 200.oo bucks
http://www.boschtools.com/tools/tools-detail.htm?H=175980&G=54940&I=69851

G0510Z 3/4 HP Shaper
at @ 315.oo bucks
http://www.grizzly.com/products/g0510z

http://www.grizzly.com/products/searchresults.aspx?q=shaper&submit.x=0&submit.y=0
http://www.grizzly.com/catalog/2007/Main/515

Bj ;)
 

·
Registered
Joined
·
23,786 Posts
Hi
Then you'er set get the card out and put it to work :)

Bj :)


Dohcser said:
I apologize what I failed to mention is that I already have a Bosch router.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top