Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
First, hey all! great forum! I've been reading for sometime now and decided to take the plunge (no pun intended) and join. My question is: Has anybody had any experience with mounting a Festool OF 1400 on a table? I know it is pretty much a dedicated plunger, but was considering making a table set up for it & was wondering if anybody else tackled this project & what they liked/disliked about it, hints, tips, products, materials, insert plates, plans etc. Also, There are only the (2) tapped holes in the base it's mounted on, are (2) screws enough to keep it securely mounted? Thanks all!!!
 

·
Official Greeter
Joined
·
19,728 Posts
G’day

Welcome to the router forum.

Thank you for joining us
 

·
Registered
Joined
·
10,671 Posts
Greetings and welcome to the router forum. Thank you for joining us, and remember to have fun, build well and above all be safe.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top