Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am new to the cnc world. I have built a 3018 Pro cnc router and have access to a large cnc router. I wanted to start my projects with a lighthouse for the local middle school. I have used 11 different programs and cannot get the JPG sketch into a 3d DXF file to convert to a gcode. If anyone out there can help me kick off this new hobby I would appreciate it very much. Thank you. Russ :frown:
 

·
Administrator
David
Joined
·
3,979 Posts
Welcome to the forum, Russ! Add your first name and location to your profile so they show in the side panel.

Hopefully you tried these programs in trial mode rather than purchasing that many. Like Mary asked, which program are you using or want to use? We can start there but without knowing that it's hard to help.

David
 

·
Official Greeter
Ross
Joined
·
10,050 Posts
Welcome to the forum Russ.
 

·
Retired Moderator
Joined
·
16,385 Posts
Hi Russ and welcome.
 
1 - 5 of 5 Posts
Top