[bobj3]

Thanks Lee
Looks like they both work about the same way.
The only error I run in to sometimes is keeping the RadioArmSaw table true with the arm of the saw, if I run in on a 45deg. slot. it will not be true on the outer end, so I need to shim the stock,just a bit.
But other than that it works great...for the hard router cuts I sometimes make.

http://www.routerforums.com/attachment.php?attachmentid=2656
http://www.routerforums.com/attachment.php?attachmentid=2657
http://www.routerforums.com/attachment.php?attachmentid=2658

http://www.routerforums.com/showthread.php?t=2742


Thanks again for the snapshots.
Bj

 

[bobj3]

Thanks Lee
I will give that a shot...

Bj