Router Forums banner
1 - 1 of 1 Posts

·
Registered
Mike
Joined
·
3,948 Posts
The ports and pins settings for inputs are for machines using a parallel port. They are not used with that USB control card. That is why you get that error message.

Here is a schematic of how to wire that card. The limits switch connections are shown on the lower left of the drawing. Limits use IN2 and homing uses IN3. IN1 is for the E-Stop and IN4 is for a touch plate.

Circuit component Product Line Font Rectangle
Circuit component Product Line Font Rectangle
Circuit component Product Line Font Rectangle
 
  • Like
Reactions: jw2170
1 - 1 of 1 Posts
Top