Router Forums banner
1 - 1 of 11 Posts

· Registered
3 Posts
Hello John,
Thanks for the Welcome,
This is all new stuff for me, But I have been looking at CorelDraw as a CAM software programme,
Would this work for me ??
Any Advice, Welcomed,

Look on facebook, there are several active groups, one is Carveco. It is the successor to ArtCam by AutoDesk. There is a learning curve with most things, but the community surrounding the software and vendor support is key.

There are ways to get around paying for software but that is a hobby in itself. Carveco is cheaper than Vectric. Vectric has die hard fans to whom the significant front end expense is not a problem.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.