Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Bosch 1619

I have the Bosch 1619 mounted in Vertias router table . I think it is an excellent chioce for table mounting. It has plenty of power. I will be doing some raised panel doors soon. I like the fact that I can use a 3 1/2" raised panel bit that will have clearance in the router base.
Hi,
just noticed your comments

I also have the 1619 mounted in the veritas table.
I have done some experimenting with raised panel bits and
found that a parallel bar clamp is an excellent safe way to
hold my work, especially for free hand and those 3 1/2" bits.
Lots of weight to the bar clamp and it gives good control.

A late tip, but hope useful, Cliff
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top