Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
undefinedundefinedundefinedI finally got my m12v out of the box and into a table. I did some basic edge designs and did a couple of prototypes of some chair rail moulding. Everything seemed to be going great. I bought a 3/8" spiral upcut bit about 3 weeks ago at a woodworking show. It was from a Canadian company called Cutting Edge. I finally got around to using it tonight. I didnt want to stay inside the collet. It kept riding up. I havent had any problems with my other bits. Also, my Hitachi is not the standard 2 wrench system. It has the "new and improved" 1 wrench and a locking mechanism(BOOOOOO).My question is, has anybody had any problems with these bits or the Hitachi collets.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top