Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I used this router for 4 hours this morning on a large frame for a mirror. I didcover I needed to do a little touch up and as I was setting the depth of the bit I noticed I could move it around with my fingers. The threads on the shaft and in the chuck look perfect except I noticed there is a lot of play until the chuck seats. These do no appear to be tapered threads but act like them. Sorry for the long winded way to get to my problem and question. How can you tighten the chuck? I see no spindle lock and all I can do is finger tighten and soon as you start it is loose again. Is there a solution or suggestion or is it time to retire it. It has been a great piece of equiptment

Thank you
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top