Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I just recently bought a Hitachi M12v Router to go in my Router Workshop table. The bits (happened with a spiral and a rabbet bit) have a tendency to pop out of the collet when using a 1/4 inch collet. I don't have that problem when using the 1/2 collet. All of the slits are aligned on both the 1/4 inch insert collet and the 1/2 collet. I contacted Hitachi and they sent me another collet set. I still have the same problem.

I was wondering if there were anyone else with the same problem and if was possible to solve it.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top