hitachi mv12 roter mounting for a raised pannel bit

Welcome to the Forums rjb. Glad to have you as a new member. Hope all your questions will be answer by our members.

Hi rjb

Most do, here's show and tell how to do it
http://www.woodshopdemos.com/cmt-jr6.htm

But if you also want to use the ears when you use the router as a plunge router you can put in a 1/2" to 3/4" spacer to drop the router base under the router table,the panel bits don't need to drop below the table top to far.

Bj

rjb said:

the clearance in my mv12 is not big enough to allow a pannel raising bit through should i cut out the bushing holders that come from the factory or is there anouther way to do this?

Click to expand...

If you do decide to use template guides in the future, the small oak park plates take the larger template guides, and are available for only $20.

I personally like the larger guides (I got mine from lee valley).

Hope this helps

W e l o c m e . . A b o a r d . . rjb !!

How about that for an answer to your question!! Thanks Bob!

Stick around... we can help you in all kinds of ways...

Enjoy!