[Levi88]

Hello everyone,
I recently purchased a used edgebander.
The machine works fine, and I like it a lot, since most of adjustments are made on computer.
The problem I have with, that after the transport I reajusted a little but I cannot save the settings, so each time I start the machine I need to type in motors pozitions.
There is an option to save it, but it asks for password, and administrator user. Anyone had experience with this ?
It would be necessary to call brands tehnician ?

 

[old55]

Welcome to the forum.

 

[jw2170]

G'day Levi, welcome to the forum.

You may have to wait until someone familiar with that equipment comes on board...

Could the person you bought from give you the password?

 

[Levi88]

Welcome to the forum.

Thank you!

 

[Levi88]

G'day Levi, welcome to the forum.

You may have to wait until someone familiar with that equipment comes on board...

Could the person you bought from give you the password?

Thank you very much for your time answering!
I did ask the seller, he recommended to check the computer box, but it wasn't there. He than said, he spoke to manufacturing company, they told him that the company is not giving out passwords, need to call their tehnician .